Thermic Fluid Pump Packing

Hotpack™ is the ultimate Thermic fluid pump / Hot fluid pump packing in set form. Gone are the days of leaking pump beyond control. Forget about installing expensive mechanical seal.

ADVANTAGES OF HOT PACK™ ARE

• Absolute control on leakages
• Pump runs cooler.
• Easy on shaft, No shaft damage.
• Very long gland life.
• No need to replace the entire set, just add one more ring if required.
• Convenience - ready to use gland in correct size.
• Reduces inventories - saves energy.

LEAKAGE RATE/ shift	LEAKAGE LOSS
One Drop Per Second	1.5 Liters
Two Drops Per Second	4 Liters
Stream Breaks into Drops	30 Liters
1.5 mm Stream	106 Liters
3 mm S	333 Liters
4.5 mm STREAM	545 Liters
6.5 mm STREAM	1180 Liters

APPLICATIONS

HOT PACK™ can be used to pack Thermic fluid pumps, Hot water pumps, Condensate pumps or Boiler feed water (heated) pump. Can be supplied in any required size.

CASE STUDY

Earlier packing used was Graphite / Asbestos or packing in ALUMINIUM foil. Leakage rate was @ 40 - 60 drops per minute. Shaft/Sleeve scoring was found. Life was @ 25 - 30days. After replacing this with HOTPACK, leakage was reduced to 2 drops / min. AND PAYBACK WAS 15 DAYS.

HOTPACK™ IS AVAILABLE IN ALL THE SIZES REQUIRED BY YOU.